Week 8

Device casing - top ends

Device casing - middle top

Flowchart for improved code

May 29th - After discussing with the group and Dr. JAK about the LED on and off button and clarifying about the specifications of the voltage requirement of the button, we concluded that we could go ahead and solder the button connections. I went to the Maker Lab with Rafael to solder the wires and test the button. The button worked fine but the measurements given by the device were incorrect. We decided to wait for the casing and mounting the circuitry before making further changes on the code.

May 31st - I went to the Maker lab with the casing design made by Patrick to start the printing job. It will be ready by the next morning.

June 1st - I went back to the Maker lab in the morning to pick up the part but there was a clogging problem with the printer and the job had to be restarted. I came back once more in the afternoon to find that the job will again have to be restarted because the support material was not printed along the casing and the job won't be able to finalize.

June 4th - I have been working on updating presentation slides, figures and final report.

Reflection: I just hope we can get all done and ready for tomorrow deadline!